Bacharach Portable Combustion Analyzer Spécifications télécharger pdf (Page 20)

PCA



3 Manual

20 0024-9472 Rev 3

CHAPTER 3. INITIAL SETUP

3.1. Overview

Before configuring or using the PCA

3, you MUST:

•

provide power

•

connect the probe and hose assembly.

3.2. Power

Three options are available to power the PCA

•

disposable alkaline batteries

•

rechargeable NiMH batteries

•

AC power adapter.

If you are using either alkaline or NiMH rechargeable batteries to power the

analyzer, follow the instructions below to install or replace the batteries.

•

Remove the battery cover from back of unit (Figure 3-1).

•

Remove (and properly dispose of) any old batteries.

•

Install a set of four ‘AA’ alkaline or NiMH batteries, per the “+” and “-”

markings inside the battery compartment.

•

Replace the battery cover.

Figure 3-1. Battery Cover and Compartment

The AC power adapter is capable of powering the analyzer on a continuous

basis. The adapter plugs into an appropriate 100-240 VAC, 50/60 Hz wall outlet,

and produces an output of +6 VDC. The adapter’s output connector plugs into

the analyzer’s POWER jack located on the bottom of the unit (refer to Figure 3-2

on page 22).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Pas de commentaire

Bacharach Portable Combustion Analyzer Spécifications Page 20