Bacharach Portable Combustion Analyzer Spécifications télécharger pdf (Page 29)

PCA



3 Manual

0024-9472 Rev 3 29

Figure 4-7. Time Setup

4.9. O

Reference Setup

The measured values of CO, NOx, and SO

can be individually referenced to a

specific O

percentage of between 0 and 15%. Individually set up the O

reference value for each of the above gases as follows.

1. Display the MAIN MENU by pressing the MENU (F2) button. If

necessary, press ESC until MENU appears above F2.

2. Use the ▲▼ buttons to highlight SETUP, and then press ENT to display

the SETUP MENU.

3. Use the ▲▼ buttons to highlight O

REF, and then press ENT to

display the O

REFERENCE screen.

4. Use the ▲▼ buttons to highlight the desired measurement, and then

press ENT to display the REF TO O

screen for that measurement. In

the example shown, CO has been selected.

5. First use the

◄►

buttons to move the cursor across the screen until it is

over the digit to be changed, and then press the ▲▼ buttons until the

desired value is displayed.

6. Press ENT to save the displayed value and re-display the O

REFERENCE screen, or press ESC to abort this procedure and retain

the old O

reference value.

7. If the O

reference value for more than one gas is being set, repeat

Steps 4, 5, and 6 for each measurement.

Figure 4-8. O

Reference Setup

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 99 100

Pas de commentaire

Bacharach Portable Combustion Analyzer Spécifications Page 29